Search:

Type: Posts; User: chuff

Search: Search took 0.00 seconds.

  1. QLD Arrived yesterday. Fitted today. PERFECT!!...

    Arrived yesterday.

    Fitted today.

    PERFECT!!

    Thanks Eric.


    394908
  2. Replies
    10
    Views
    978

    Keen to find a solution I also posted this...

    Keen to find a solution I also posted this problem on another forum and the problem was resolved.

    In mrpete22's video it clearly shows that the pin went through the collar, then the worm drive and...
  3. Replies
    10
    Views
    978

    Hi BaronJ, Thanks for your reply. I'm not...

    Hi BaronJ,

    Thanks for your reply.

    I'm not sure exactly which picture you're referring to but I can assure you there is absolutely no crud anywhere within the apron. I'm not sure if you viewed...
  4. Replies
    10
    Views
    978

    Hi pipeclay, Thanks for your post. As far...

    Hi pipeclay,

    Thanks for your post.

    As far as I can tell every other part of the lathe/gear train is working fine, and yes, when it seized up the drive belt just slipped & I turned it off...
  5. Replies
    10
    Views
    978

    Hi lamestllama, That rod is the lock out rod...

    Hi lamestllama,

    That rod is the lock out rod that locks out the half nut engaging lever if the feed engaging lever is set to the upper or lower position to provide drive to the longitudinal or...
  6. Replies
    10
    Views
    978

    I'm not sure what you mean. Cut it how? I...

    I'm not sure what you mean. Cut it how?



    I have no idea, but prior to repairing the clutch engagement it was working fine as I could engage the gearbox, the threaded lead screw would rotate...
  7. Replies
    4
    Views
    1,032

    Hi Grahame, Perfectly understandable about the...

    Hi Grahame,

    Perfectly understandable about the way your forum works in order to minimize spam. There is nothing more annoying than idiots polluting valuable resources such as this.

    Apologies...
  8. Replies
    4
    Views
    1,032

    Perfect. I suspected that may be the case. ...

    Perfect.

    I suspected that may be the case.

    Thanks.
  9. Replies
    4
    Views
    1,032

    My Posts Aren't Appearing

    I started a new thread in the Sheraton section, posted it and it doesn't seem to have been posted.

    I've also had trouble replying in existing threads.

    Am I doing something wrong?

    Thanks.
    ...
  10. Replies
    10
    Views
    978

    Worn Drive Siezed

    Hi All,

    A few years ago I was given an old Sheraton lathe that had been sitting outside a factory under a tarp for many, many years. It was pretty rusty and seized up but after a lot of...
  11. QLD Hi Eric, If you still have some of these...

    Hi Eric,

    If you still have some of these outside jaws available I'd like to purchase a set.

    I tried to send you a PM but was unable to. I'm a new member so I may not have privileges to do so...
Results 1 to 11 of 11