Search:

Didn't know they made new ones like this :oo:...

See ad in Woodwork Marketplace.

See ad in Woodwork Forum. Pickup from Caringbah (Sydney South) or Nowra area.

She's right!
Because she knows who would have to look after you :D

DONE, Sending to aarggh via Woodwork forum.

See ad in Woodwork Forum in "Free/Swap" section

Just make sure you download the manual that you need. There are two, H1 and BD600, and you would not be happy if you spent hours reading the wrong one. If in doubt, ring Conon.

:whs: I started with BobL's "VFD for newbies", then got hold of a manual, and then made my decision - all as suggested by BobL. And yes, I did pay a bit more to buy locally from Conon.
They are...

So am I! After you put me on the right track I decided to push my luck further aiming for an overall range between 25 and 90Hz AND with my preferred working range of 50 to 60Hz at the middle of the...

This VFD has settings for Maximum Output Frequency (up to 600Hz) and for a Run Upper Limit as well. Although I have set the Maximum Output to 200Hz, the Run Upper limit is set to 90Hz and this is...

Hey, Techo1, go to the top of the class! Fiddling around with the F05.19 setting I found that the range would start at that percentage of the maximum frequency, and this got me on the right track....

Yes I am using the analog input and have tried quite a few settings. The supplier reckons it's a structural (his words) limitation of the pot. Am just using it as is for the time being and will have...

Motor now gone to new home via Woodwork Forum. DONE

Thanks to all for your suggestions. So far no success, but as the only problem is the dead zone of the knob I think I'll just live with it.

Cheers, Gary

Electric motor has now gone to its new home via the Woodwork Forum.

Thanks, but it is definitely a Linear pot.

My new VFD setup on the Woodfast lathe is working well but the Remote speed/frequency control pot has me puzzled. With a frequency range set from 20 to 90Hz I have a dead zone where the knob rotation...

FREE – ELECTRIC MOTOR
CMG 3 phase induction motor 415v - now wired in Delta ready for running VFD from 240v AC power, or can change back to original 415v 3 phase star. Came from Woodfast lathe as I...

See full details in Woodwork forum Market Place.