Search:

Thanks Michael, I fear you are correct but nothing ventured, nothing gained. I have an acquaintance nearby I can borrow more info from. I only have the original operators manual. Yes, I would need...

If anyone would like to discuss CVA lathes I have one that was purchased new in 1966. I would like to add a taper turning attachment to it if I could find one. I would need the telescopic cross slide...

I guess this is a bit of a long shot but if anyone can help me find a lonely taper turning attachment looking for a new home I would be most appreciative. I’m in Melbourne eastern suburbs.

Thanks Grahame for that clarification. When you put those two points together like that it is very clear.
Hugh

Thanks Grahame, yes it all seems fine and I have successfully posted since.

I had a reply to my question asking for comments about a supplier. The replier was not prepared to comment on...

Thanks racingtadpole. I will give them a go and hope I don’t have to negotiate later. I would hope that the forum rules would permit polite reporting of facts without opinion but I don’t read that...

Thanks Grahame. That empty title box looked so inviting!
Hugh

I have written a long post to add to the M&G productions ER .........review. I pressed “submit” and assumed it had gone. Some time later I realised it was still sitting there waiting to be submitted...

What great thread. Thanks all. I can’t find an available ER32 to D1-3 and I share the concern that I might buy one that didn’t run quite true anyway so I’m happy to cobble one together. I see that...

Hi clear out/H,
I hear what you are saying about the great OHS fiasco almost all of which is just an enormous cost to industry and a waste of time and effort. The last raid we had by Worksafe...

Thanks Grahame, it looks like I wasn’t looking for SETTINGS at all. My email is fine but the message is still there. I’ll just ignore it.
Hugh

Thanks Grahame. I have a message from Neil asking me to go to SETTINGS to make sure my email address is up to date. I haven’t been able to find SETTINGS.
Hugh

On this CVA there is a rotation detector on the motor shaft that, on rotation, closes a set of contacts that are in series with the normally closed contacts in the contractor that is switching the...

I’m going to use my actual name as my username which is Hugh Venables. I live in Ferntree Gully Vic with my wife Di and my garage. I grew up in Eltham and completed HSC at Eltham High. I was...