Search:

It's this one....
https://unimig.com.au/product/sb36-binzel-style-mig-torch/

I measured my M8 tip holder this morning and it's 28mm, so the 'short' variant.
Just wasn't sure if the longer one...

Hi all,
I've got to order an M6 tip holder for my SB36 torch and there seems to be two variants, short at 28mm and long at 32mm in both M6/M8.

Can someone tell me which one is suitable for...

@morrisman

Thanks! you were right- it's a 1936 Colchester Bantam.

I was thinking same, same, different due to the slightly different gearcover and halfnut lever.


This is a pic of a...

Hmmm,

if that's worked out fine for you then I might have my drive pulley on that side too...

That last photo definitely looks the way to go- clearance for the belt on the casing with that...

Just in case anyone else gets stuck-

Years ago as an electrical fitter at a steam boiler factory this kind of fun was gong on all the time- an extractor with good heat and lube usually took care...

Ray, hard to see from the pic, but how much separation is there between the belt pulley and the motor pulleys, and have you found any issues with mounting the motor pulley on that side with the...

First up, thankyou Grahame for the welcome!


@morrisman I think Demco was definitely a rebadger- it would be nice to find out where they sourced from, the Colchester Co definitely looks close....

Hi all,

a few years back I scored myself a Demco lathe for $150.
No motor, pulleys, countershaft brackets etc as I'm fairly certain it was an overhead shaft model.
At that price I'm not going...