Search:

Type: Posts; User: Bushranger

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,619

    I did some parting off on 9"AR today with a...

    I did some parting off on 9"AR today with a similar tool, but in brazed carbide in a shop made tool holder. Low speed and feed and it went very well. These little lathes are quite something.
  2. Thread: Hi, all.

    by Bushranger
    Replies
    7
    Views
    1,913

    Thanks, Ray-s and old-1955.

    Thanks, Ray-s and old-1955.
  3. Thread: Hi, all.

    by Bushranger
    Replies
    7
    Views
    1,913

    Thanks very much for the comprehensive...

    Thanks very much for the comprehensive description, Caskwarrior.

    If it's the same problem as you experienced, I might make up a couple of spares of the damaged part/parts. Just in case.
  4. That's some fantastic work! How long did it take...

    That's some fantastic work! How long did it take you?
  5. Thread: Hi, all.

    by Bushranger
    Replies
    7
    Views
    1,913

    Thanks for the welcome, Grahame. I'm looking...

    Thanks for the welcome, Grahame. I'm looking forward to participating in some interesting discussions on here.
  6. Thread: Hi, all.

    by Bushranger
    Replies
    7
    Views
    1,913

    Hi, all.

    Hi, all. This looks like a good forum to be on, lots of knowledgeable people with good advice.

    Speaking of which (probably bad manners to ask questions on my first post, but I'm in a bit of a...
Results 1 to 6 of 6