Search:

Type: Posts; User: Faux Forg

Search: Search took 0.00 seconds.

  1. Three machines were picked up this morning. :) ...

    Three machines were picked up this morning. :)

    The radial arm drill went to Ian (and the welder last week). The lathe and another machine went to a friend of a forum member too. All that's left...
  2. Hi Ian, The drill and welder are still...

    Hi Ian,

    The drill and welder are still available (for free). When I scroll to the end of the page I can see the photos of them. They're available for inspection during business hours at...
  3. After receiving zero interest from anywhere, the...

    After receiving zero interest from anywhere, the spark eroder, vacuum pump, dust extractor and lockers all went for scrap this week. Bit of a shame, as the spark eroder was seriously well built...
  4. The lathe has been sold this morning :)

    The lathe has been sold this morning :)
  5. Just found out today that the controller for the...

    Just found out today that the controller for the spark eroder no longer works. Our electronics guy spent a while looking it over, before declaring it dead and scavenging some of its parts. The...
  6. To answer some questions that i've been asked; ...

    To answer some questions that i've been asked;

    The drill's minimum dimensions (with the arm down) are 1250 long, 650 wide, and 2050 high. A new HAFCO equivalent is ~1300kg

    The lathe's...
  7. I've just sold the power hacksaw and parts washer...

    I've just sold the power hacksaw and parts washer to Andrew (trail). Thanks! :)
  8. Machine shop clearance sale. Lathe, EDM, drill, saw, etc for cheap

    Hi All,

    Takai Spotted this on another forum and recommended I post these machines over here. Sorry about being the new guy who just posts a for sale add. Promise I'll be back later :-

    A major...
Results 1 to 8 of 8