Search:

Type: Posts; User: Stan Martins

Search: Search took 0.00 seconds.

  1. After doing some more testing I belive this is...

    After doing some more testing I belive this is the issue. I'm just going to buy a suitable replacement on ebay and hope it works. Thanks for all the help, guys!:)
  2. Ok, I did some calculations and I'm pretty sure...

    Ok, I did some calculations and I'm pretty sure this is the problem. The rewound relay only has 7.2 ohms of resistance where as the CR2 relay has 400 ohms.
  3. Well, I checked the voltage on the board input...

    Well, I checked the voltage on the board input again and i now measure 30v. So that seems to be working now. I also checked the voltage across the CR2 relay and found that there was only around 4.2v...
  4. Right. I'll have a look tomorrow and see if I can...

    Right. I'll have a look tomorrow and see if I can find anything suspicious.
  5. Ozito MWR - 135 -- Welding current but no motor or feed

    I picked this welder off the side of the street a couple years ago and have only just gotten round to having a look at it.
    So far I've:

    Fixed the CR1 relay and checked to make sure CR2 is...
Results 1 to 5 of 5