Search:
Type: Posts; User: S.W
Search: Search took 0.00 seconds.
-
19th Aug 2023, 10:28 PM
Thread: A technical (drawing) question
by S.W- Replies
- 11
- Views
- 1,157
AS1100 gives general tolerances for dimensions...
AS1100 gives general tolerances for dimensions that are not otherwise specified on the drawing, with different classes (medium being the most common). It is a graduated system depending on the...
-
3rd Apr 2023, 01:15 PM
- Replies
- 6
- Views
- 1,278
Heading there in a couple of weeks, looking...
Heading there in a couple of weeks, looking forward to the visit.
-
22nd Mar 2022, 08:35 AM
Thread: 3.5T Flat deck trailer build
by S.W- Replies
- 102
- Views
- 23,281
Looks great Steve, I've enjoyed following along.
Looks great Steve, I've enjoyed following along.
-
23rd Jul 2021, 03:20 PM
Thread: 8 x 6 trailer design
by S.W- Replies
- 8
- Views
- 3,400
2T ATM is achievable with a 50mm square axle and...
2T ATM is achievable with a 50mm square axle and appropriately rated leaf springs
You will need to plate the trailer under 2T to avoid the requirement for breakaway brakes. That is why a lot of... -
9th Apr 2021, 09:29 AM
Thread: Tractor grapple
by S.W- Replies
- 45
- Views
- 16,251
Me too, I only remove it where I am welding.
Me too, I only remove it where I am welding.
-
26th Mar 2021, 11:09 AM
- Replies
- 12
- Views
- 3,909
Single pass is more than sufficient. Have a...
Single pass is more than sufficient. Have a practice on some scrap beforehand to get the settings right before you do the actual cart.
-
19th Mar 2021, 08:59 AM
Thread: TAFE project die holder
by S.W- Replies
- 25
- Views
- 5,144
Paperweight?
Paperweight?
-
26th Feb 2021, 08:41 AM
Thread: Flat deck trailer refurb
by S.W- Replies
- 7
- Views
- 4,143
Sounds like a good plan Steve. For the drawbar on...
Sounds like a good plan Steve. For the drawbar on a trailer that size I'd be going with 100x50x3.
-
6th Apr 2020, 12:57 PM
Thread: Homemade lathe in the making?
by S.W- Replies
- 145
- Views
- 37,720
not sure what the chinese lathes thread has to do...
not sure what the chinese lathes thread has to do with my reply... I was suggesting that Gazza should take the engine that he wants to bore out to and machine shop/reconditioner and have them do the...
-
6th Apr 2020, 11:08 AM
Thread: Homemade lathe in the making?
by S.W- Replies
- 145
- Views
- 37,720
Why not just take the cylinder to a machine shop...
Why not just take the cylinder to a machine shop and get it bored out properly? Seems like lots of money to spend building something to then have to spend more to do the job properly later after you...
-
12th Feb 2015, 11:00 PM
Thread: Trailer Safety Chains
by S.W- Replies
- 16
- Views
- 11,082
Wow! Someone's power trip went too far that day....
Wow! Someone's power trip went too far that day. If you need a welding certificate to weld the coupling & chains on, then they might as well say you need one for the whole trailer. Not much point...