Search:

Type: Posts; User: Brett57

Search: Search took 0.00 seconds.

  1. Replies
    19
    Views
    2,674

    FOOT Switch

    Joe, I see your drills have foot activated stop switches. Do you know where these can be bought?
    Cheers
  2. Replies
    6
    Views
    735

    Drilmor drill press

    I am not sure where to post this question.
    I have a drilmore drill press from the 1980 ‘s which has a worn chuck. If you rotate a drill bit in the chuck say 445 deg each time you do that and nib up...
  3. Replies
    4
    Views
    1,664

    Thanks everyone for your feed back. I think I...

    Thanks everyone for your feed back.
    I think I will pass on it.
    chhers
  4. Replies
    4
    Views
    1,664

    Tecnica inverter welder

    Tecnica 1600
    inverter welder
    Can anyone shed some light on this welder please and any comments on if it is good, great or useless.
    cheers
  5. Replies
    1
    Views
    1,338

    NSW Sold

    I cannot see how or where to edit the post.
    BUT this has bee SOLD
  6. Replies
    1
    Views
    1,338

    NSW NSW 3 phase 415V CIG Trans mig 180

    3 phase 415 V Trans mig 180 needs a new home.
    needs earth lead and gas cylinder.
    1980’s welder solid as a rock.
    $200
    pm me for photos as I cannot seem to upload them.
    located Warrimoo NSW 2774
  7. Thread: For sale.

    by Brett57
    Replies
    2
    Views
    787

    For sale.

    Hi all can you help ?
    i cannot see the find a “ for sale “ page on the metal work forum.
    I have an old 3 phase msg welder I want to sell.
    cheers
  8. Replies
    5
    Views
    917

    thanks again Grahame, I had already found the...

    thanks again Grahame,
    I had already found the info from the first link by doing a search before I posted but thanks all the same. The second link was great as it reminded me how to remove the chuck....
  9. Replies
    5
    Views
    917

    thanks Grahame, I did not realise that I had...

    thanks Grahame,
    I did not realise that I had joined so long ago. Quite the contrary it is often said I talk too much and certainly like a conversation. I am predominantly a wood worker so most Posts...
  10. Replies
    5
    Views
    917

    Drilmor 13mm early 80’s service

    Hi all,
    not sure if this is the right place for this question but….. I have an early 80’s Drilmor 13 mm.
    drill press. I think that the spindle or quill has been bent. I know this seems unlikely but...
  11. Thread: CIG Transmig

    by Brett57
    Replies
    4
    Views
    1,657

    CIG Transmig

    Hi all new to this forum.
    I have acquired a CIG Transmig from mid 1980’s.
    I do very little welding and this is a big unit and it is not worth the cost of the argon bottle just to have it sitting...
Results 1 to 11 of 11