Thread: Looking for help - Someone with CNC Lathe

I'm in need of someone with a CNC lathe to do some turning for me. I'm a woodworker not a metal worker. Never have been, never will be, so please bare with me here.

Brief (very rough) description is as follows.
I want a shaft approx. 70mm long with a 5/16 thread (the same as allthread) 20mm long at one end and a hexagonal shaft for the other 50mm or rest of the piece.

Also want something similar with thread one end and round shaft at other end which it to be fitted into a pair of bearings. Full dimensions etc upon expression of interest. I will want a few hundred of each to begin with, hopefully building to a few thousand from time to time.

Please PM me if there is any interest.

Cheers - Neil .

Neil,

I can help you out here with your turned parts, please PM or email me
the relevant information needed to manufacture the parts.

I have PM you with my email address.

Regards

Colin

Sounds nice Neil. Send me a drawing and I can let you know something about it.

Studley