Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 16 to 19 of 19
Thread: ebay sheetmetal benders
-
1st Jan 2008, 08:37 PM #16
-
1st Jan 2008, 08:40 PM #17
No Offence intended
Hey! Its the New Year
Bob ,
No offence what so ever is intended .Rather the reverse.
These forums are such a helpin so many ways!
When I can't find an answer I can always set my query out her and there is nearly always someone who has the personal experience or is able to give a decent reference to track down an answer.I have been helped so many times by those on the building side.Those who have the answers to my questions.
The thing was to give them all the necessary information about what I wished to do for them to provide a qualified opinion as to what I should do.
That was what I am trying to convey to those posters that make an unnecessary long thread by not providing adequate information in the initial question.
regards
Grahame
-
1st Jan 2008, 08:52 PM #18
You're right Grahame, I never took your post as critical etc.
I tend to pare questions & comments back to the bare bones perhaps a bit too often
-
8th Jan 2008, 10:06 PM #19Senior Member
- Join Date
- Aug 2005
- Location
- Perth
- Posts
- 185
have a read
http://www.woodworkforums.ubeaut.com...t=simso+bender
cheapest way of getting a decent pan brake, if you cant make it then pay someone to do it for you, will last longer than yours or my lifetime and you can hand it down to your kids
Steve
Similar Threads
-
sheetmetal differences?
By metaboman in forum METALWORK GENERALReplies: 16Last Post: 17th Feb 2012, 08:47 PM -
Already problems cutting sheetmetal.
By metalnwood in forum METALWORK GENERALReplies: 21Last Post: 23rd May 2007, 07:52 PM