Needs Pictures: 0
Results 1 to 4 of 4
Thread: BS-0 between centres
-
11th Jan 2021, 07:32 PM #1Senior Member
- Join Date
- Nov 2012
- Location
- Mid North Coast NSW
- Posts
- 422
BS-0 between centres
G'day,
There's this yoke thing that came with my BS-0 for turning between centres.
No explanation in the manual about it and I don't get how to use it.
There are more screws in a packet for the yoke (not shown in the photo).
Ok so, the dead centre will go into the spindle of the BS-0 after removing the chuck, but then what ?
Is there a dog missing or something ?
bs0 thing.jpg
-
11th Jan 2021, 08:11 PM #2Golden Member
- Join Date
- Oct 2001
- Location
- ACT
- Posts
- 667
Phaser its for when you are using an arbor and you have a drive dog screwed on the arbor that locates in the slot in the yoke (your project, gear blank, or whatever is on the arbor). The screws in the yoke clamp onto the dog so there is no slop to mess with your dividing/divisions.
Harold Hall has a reasonable explanation and pictures Working between centres with a dividing head
-
12th Jan 2021, 12:27 AM #3Senior Member
- Join Date
- Nov 2012
- Location
- Mid North Coast NSW
- Posts
- 422
-
15th Jan 2021, 11:10 AM #4Senior Member
- Join Date
- Nov 2012
- Location
- Mid North Coast NSW
- Posts
- 422
Fixed....
drive dog.jpg
Similar Threads
-
Ball Centres
By Bryan in forum METALWORK GENERALReplies: 19Last Post: 4th Jul 2012, 04:42 PM -
Turning between centres ?
By morrisman in forum METALWORK GENERALReplies: 4Last Post: 14th Dec 2011, 09:14 PM -
Using a Between-Centres Boring Bar
By franco in forum METALWORK GENERALReplies: 68Last Post: 17th Jan 2011, 05:35 PM -
Between centres?
By Filby in forum METALWORK GENERALReplies: 52Last Post: 17th Jul 2009, 05:28 PM -
Turning b/w centres
By Tiger in forum METALWORK GENERALReplies: 35Last Post: 17th Jun 2008, 12:31 PM