Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 15 of 16
Thread: A great site to visit.....
-
28th Jan 2012, 03:53 AM #1
A great site to visit.....
I have had this site in my fav list for soooo long it's not funny..
It was one of those save it for later things that was forgotten only to be re found this evening while looking for something else.
Turns out to be a fantastic site so I thought I would post it up for those that may not have been for a visit yet..
Happy reading. The Gizmologist's LairWarning Disclaimer
-
28th Jan 2012, 10:16 AM #2Most Valued Member
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 9,088
Hi Matthew
I like the guys thinking.
How To Cook A Huge Pizza
Thanks
Stuart
-
28th Jan 2012, 10:47 AM #3Most Valued Member
- Join Date
- Jul 2006
- Location
- Athelstone, SA 5076
- Posts
- 4,255
-
28th Jan 2012, 12:54 PM #4Dave J Guest
Looks like a good site Matt.
Stuart wouldn't all the cheese run off the end.
Dave
-
28th Jan 2012, 12:56 PM #5Most Valued Member
- Join Date
- Jul 2010
- Location
- Melbourne
- Posts
- 9,088
Hi Dave,
Did you see the second picture?
Stuart
-
28th Jan 2012, 12:59 PM #6Dave J Guest
Now I see, LOL
Dave
-
28th Jan 2012, 01:19 PM #7
good
Quite a good site . I printed out the info on the bearing nomenclature . Now I can impress the staff at BJ bearings with my knowledge MIKE
-
29th Jan 2012, 09:04 AM #8Most Valued Member
- Join Date
- Jul 2006
- Location
- Athelstone, SA 5076
- Posts
- 4,255
-
29th Jan 2012, 02:30 PM #9Dave J Guest
Right O I know, anyway how do you have time to post, is that top taper bearing fitted yet,
Dave
-
29th Jan 2012, 06:05 PM #10
Had to have a second look at the pizza oven. Looked when thread was first posted just saw the pizza on a angle. After Stustoys comment realised what it was about.
Squirrel.
-
30th Jan 2012, 10:08 AM #11Most Valued Member
- Join Date
- Jul 2006
- Location
- Athelstone, SA 5076
- Posts
- 4,255
-
30th Jan 2012, 05:17 PM #12Dave J Guest
That wouldn't be Ray would it,
It is heat treated in the new oven now,
Dave
-
30th Jan 2012, 10:41 PM #13
-
30th Jan 2012, 10:55 PM #14Dave J Guest
He wont need it for a while now, he will be to busy aligning the headstock on his new lathe, LOL
Dave
-
30th Jan 2012, 11:00 PM #15