Thanks Thanks:  0
Needs Pictures Needs Pictures:  0
Picture(s) thanks Picture(s) thanks:  0
Results 1 to 7 of 7
  1. #1
    Join Date
    Nov 2019
    Location
    Australia
    Age
    47
    Posts
    6

    Default Sheraton conquest inquiry

    Good morning all

    I am looking for the wiring diagram for the conquest.
    The motor on this as you all would be aware has two sets of windings.
    The majority of the starter panel is missing including contactors .
    I have found the uk site but before buying a book just for the wiring diagram thought I would see if someone could help out.

    Regards

    Nick

  2. #2
    Join Date
    Nov 2010
    Location
    Frankston south
    Posts
    102

    Default

    whilst I don't have the wiring diagram, I think I have some pictures of the original layout of mine. I replaced the motor with a single speed motor and VFD.
    I'll dig them out after I finish watching the Sepang Motogp.

  3. #3
    Join Date
    Nov 2019
    Location
    Australia
    Age
    47
    Posts
    6

    Default

    Thank you

  4. #4
    Join Date
    Nov 2010
    Location
    Frankston south
    Posts
    102

    Default

    Your thanks where a little premature...
    I've searched all the sd cards and folders of information I have without success, i'm sorry to say. I'll keep looking and if they turn up you'll hear about it.

  5. #5
    Join Date
    Nov 2019
    Location
    Australia
    Age
    47
    Posts
    6

    Default

    No problems at all I do appreciate the effort.

    Speaking to friend whom i purchased the lathe from he said he has a frequency drive I can use if need be.

    As long as the lathe can reach its speed of 2500 rpm ill be happy .
    Im not sure if its rated to beyond that in the bearings and lubrication setup as I havnt turned up anything in my research of anyone else doing this to theirs.

  6. #6
    Join Date
    Nov 2010
    Location
    Frankston south
    Posts
    102

    Default

    The motor I have put on is rated the same rpm, I use a vector drive VFD and it supplies ample grunt at low speeds

  7. #7
    Join Date
    Nov 2010
    Location
    Frankston south
    Posts
    102

    Default

    As an addendum.....the only time I've let the lathe sing at those speeds is to polish

Similar Threads

  1. Sheraton SG
    By KBs PensNmore in forum METALWORK GENERAL
    Replies: 17
    Last Post: 14th Aug 2018, 09:44 PM
  2. Sheraton Conquest Head Gear
    By Quoll15 in forum METALWORK GENERAL
    Replies: 9
    Last Post: 7th Dec 2012, 10:04 AM
  3. Need Sheraton Conquest info
    By xXvapourXx in forum METALWORK GENERAL
    Replies: 14
    Last Post: 25th Jul 2012, 12:37 AM
  4. Sheraton CUB
    By morrisman in forum METALWORK GENERAL
    Replies: 0
    Last Post: 14th Dec 2011, 09:31 PM
  5. sheraton conquest lathe
    By leopardwood in forum METALWORK GENERAL
    Replies: 11
    Last Post: 7th Jun 2010, 08:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •