Thanks: 0
Likes: 0
Needs Pictures: 0
Results 1 to 4 of 4
Thread: brush holder springs
-
15th Jun 2020, 10:35 AM #1Senior Member
- Join Date
- Jul 2010
- Location
- Brisbane
- Posts
- 143
brush holder springs
Hi.. I need one of these brass springy thingies .. size is 3.5mm dia and about 40mm in length.. alternatively find a supplier in OZ who carries brass springs..No luck there as yet.
I had a selection of them removed from various motors over the years.. but in my shed they may never be found !
Ken.
-
15th Jun 2020, 03:44 PM #2Most Valued Member
- Join Date
- Sep 2010
- Location
- Lebrina
- Posts
- 1,910
Perhaps try a motor rewinder? What is it out of?
-
15th Jun 2020, 04:53 PM #3Senior Member
- Join Date
- Jul 2010
- Location
- Brisbane
- Posts
- 143
-
16th Jun 2020, 02:39 AM #4
Hi Kenny, Guys,
I've seen similar clips and also ones that were just a circle, a bit like a figure of eight with the top chopped off. Similar to a rubber tube retainer. Unfortunately I've nothing that I could take a picture of ! Something like this.
Hose-Clip.png
Picture grabbed online.
Actually you could use one of these by trapping your wire underneath it.Best Regards:
Baron J.
Similar Threads
-
Replacing springs?
By Legion in forum TRAILERS & OTHER FABRICATED STUFFReplies: 6Last Post: 14th Nov 2013, 08:09 AM -
Slipper springs .. does this look right ?
By kenny_10 in forum TRAILERS & OTHER FABRICATED STUFFReplies: 3Last Post: 31st Mar 2013, 10:19 AM -
Making own springs
By WA Pete in forum METALWORK GENERALReplies: 5Last Post: 12th May 2011, 12:13 AM -
Trailer springs
By Tigershark in forum TRAILERS & OTHER FABRICATED STUFFReplies: 2Last Post: 25th Feb 2010, 03:23 PM -
Cutting wire springs
By Chompy in forum METALWORK GENERALReplies: 10Last Post: 20th Jun 2006, 10:36 PM