Thanks: 0
Likes: 0
Results 1 to 5 of 5
-
27th Aug 2019, 04:09 PM #1human termite
- Join Date
- Jul 2007
- Location
- sandstone point queensland
- Age
- 69
- Posts
- 182
replacing control switch for AL330 lathe
want to replace my switch on my AL330 HAFCO lathe with the newer HZ5B-10 D008/2 SWITCH, ,and I wonder if anyone can help me? the wires on the existing switch are
1 white
2 red
3 red
4 blue
5 black..........................
6 brown 2,3 and 6 are linked with each other.
attached is a photo of new switch, and old switch (still attached to lathe)have done the changes to the new switch so it fits ,just stumped on the wiring ,
.......thanks in advance
there was a post on this but a couple of the wires on mine are a different colour
-
27th Aug 2019, 05:56 PM #2
Hi Robyn2839,
From the picture of the new switch it looks like when the switch is turned to the right, connections 2 & 4, are made and so are 6 & 8 and when turned to the left, 1 & 3 are made and so are 5 & 7. There won't be any connections made between the front and rear switch banks unless you deliberately link them.Best Regards:
Baron J.
-
27th Aug 2019, 06:08 PM #3human termite
- Join Date
- Jul 2007
- Location
- sandstone point queensland
- Age
- 69
- Posts
- 182
still not sure what wires from the old switch to connect to the new one ,but someone will haave done it as the old switches are no longer as far as I know, thanks for your help
-
28th Aug 2019, 02:11 AM #4
Hi Robyn2839,
From memory the contact layout is the same but the switch is rotated by 90 degrees.
But I have no way of checking that.
Switch.jpg
You really need a multimeter to check that this is correct. Both the front and rear sections are the same.Best Regards:
Baron J.
-
28th Aug 2019, 08:17 PM #5human termite
- Join Date
- Jul 2007
- Location
- sandstone point queensland
- Age
- 69
- Posts
- 182
pulled the switch out today to get a better look at it ,may help with id............bob
PHOTO 3 reads LA32 XK06
-101
3091
PHOTO 2 reads Ui660v Ith10A
Similar Threads
-
How to : Replacing a Lathe fwd/rev switch - HZ5B-10/2 D009
By MasterSpoon in forum ELECTRICALSReplies: 5Last Post: 28th Aug 2019, 05:47 PM -
Hafco al330 metal lathe
By robyn2839 in forum METALWORK - Machinery, Equipment, MARKETReplies: 4Last Post: 9th Jun 2019, 10:07 PM -
Replacing a Switch.
By wm460 in forum METALWORK GENERALReplies: 9Last Post: 30th Apr 2017, 10:49 PM -
N.S.W. Hafco AL330 Metal Lathe LOC: Coffs Harbour NSW
By BenM78 in forum METALWORK - Machinery, Equipment, MARKETReplies: 0Last Post: 8th Jan 2013, 05:42 PM -
Trouble replacing lathe belt
By dannyvee in forum METALWORK GENERALReplies: 3Last Post: 13th May 2011, 01:11 AM