Results 1 to 4 of 4
  1. #1
    Join Date
    Aug 2004
    Location
    Perth Western Australia
    Age
    63
    Posts
    183

    Default Surface grinder table stops

    A few months ago I made a dresser for my surface grinder, as I did not have table stops I could not use it.
    So I finally got around to making the stops.
    Stock used was 1020 round bar 38mm for the bodies and 19mm for the T nuts.
    Mark
    Attached Images Attached Images
    I've become a tool of my tools.

  2. #2
    Join Date
    Jul 2016
    Location
    Melbourne
    Age
    34
    Posts
    1,474

    Default

    Nice work!

    Sent from my SM-G973F using Tapatalk

  3. #3
    Join Date
    Aug 2004
    Location
    Perth Western Australia
    Age
    63
    Posts
    183

    Default Dresser

    Damn! I now realize the sockets milled for the holding bolts will fill up with grinding dust.
    Attached Images Attached Images
    I've become a tool of my tools.

  4. #4
    Join Date
    Sep 2012
    Location
    York, North Yorkshire UK
    Posts
    5,402

    Default

    Hello Mark, Guys,

    Nice work on those stops !

    As far as grinding dust filling the recesses, cut a couple of strips of silicon baking sheet and use double sided tape to attach it to the very top edge. It will hang down over the recesses and give them some protection.

    I use silicon baking sheets to protect the lathe ways under the chuck. One end is fastened to the top slide the other just has a couple of magnets holding it in place. Its draped so that it covers the leadscrew as well.
    Best Regards:
    Baron J.

Similar Threads

  1. Small rotary table surface grinder
    By elanjacobs in forum EBAY, GUMTREE, and other off forum sales sites
    Replies: 1
    Last Post: 3rd Aug 2020, 07:54 PM
  2. Macson surface grinder table
    By nadroj in forum WANTED TO BUY
    Replies: 9
    Last Post: 21st Jul 2019, 11:13 PM
  3. Surface Grinder Sporadic Table Lift
    By electrosteam in forum METALWORK GENERAL
    Replies: 17
    Last Post: 9th Feb 2017, 04:49 PM
  4. Surface Grinder Table Lubrication
    By electrosteam in forum METALWORK GENERAL
    Replies: 4
    Last Post: 29th Sep 2016, 03:02 PM
  5. Surface Grinder Table Feed - A Swiss Variation
    By Anorak Bob in forum METALWORK GENERAL
    Replies: 1
    Last Post: 16th Sep 2012, 01:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •