Results 1 to 3 of 3
  1. #1
    Join Date
    Oct 2019
    Location
    Nth Queensland
    Posts
    55

    Default Power feed for Model 0 Mill

    There are probably a dozen existing threads on this already however my serach skills have not uncovered them.

    (this post has subsequently thrown up a few links below to similar threads, still interested in additional thoiugh thanks)

    Who amongst you have installed a power feed on their Hercus Mill?

    Is it worthwhile, any reccommendations as to brand other advice appreciated.

    Regards

    Terry

  2. #2
    Join Date
    Nov 2008
    Location
    Perth WA
    Age
    71
    Posts
    6,458

    Default

    Terry,

    I replied then realised that this probably wasn't about homemade drives.

    Bob.

  3. #3
    Join Date
    Sep 2012
    Location
    York, North Yorkshire UK
    Posts
    6,439

    Default

    Hi Terry, Guys,

    Quite some time ago I did a write up of a table drive using a window screen wiper motor utilising a tumbler drive system for providing forwards / off / reverse feeds and a variable voltage power supply for drive speed.

    Mill-Table-drive.jpg

    This is a picture of the one currently fitted and in use !
    Best Regards:
    Baron J.

Similar Threads

  1. Power Feed For My SX3 Mill
    By wm460 in forum METALWORK GENERAL
    Replies: 0
    Last Post: 29th May 2016, 05:23 PM
  2. Mill Power Feed Clutch
    By Oldneweng in forum METALWORK GENERAL
    Replies: 41
    Last Post: 22nd Jan 2016, 01:05 AM
  3. Power Feed for Mill
    By Oldneweng in forum METALWORK GENERAL
    Replies: 0
    Last Post: 17th Oct 2015, 08:28 PM
  4. Power feed for my mill...
    By John Hill in forum METALWORK GENERAL
    Replies: 3
    Last Post: 11th Jan 2012, 08:11 PM
  5. mill power feed
    By Garry 3 in forum METALWORK GENERAL
    Replies: 4
    Last Post: 13th Dec 2011, 09:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •