Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 3 of 3
Thread: Power feed for Model 0 Mill
-
30th Jul 2021, 10:01 AM #1Member
- Join Date
- Oct 2019
- Location
- Nth Queensland
- Posts
- 55
Power feed for Model 0 Mill
There are probably a dozen existing threads on this already however my serach skills have not uncovered them.
(this post has subsequently thrown up a few links below to similar threads, still interested in additional thoiugh thanks)
Who amongst you have installed a power feed on their Hercus Mill?
Is it worthwhile, any reccommendations as to brand other advice appreciated.
Regards
Terry
-
30th Jul 2021, 07:07 PM #2.
- Join Date
- Nov 2008
- Location
- Perth WA
- Age
- 71
- Posts
- 6,458
Terry,
I replied then realised that this probably wasn't about homemade drives.
Bob.
-
30th Jul 2021, 09:10 PM #3
Hi Terry, Guys,
Quite some time ago I did a write up of a table drive using a window screen wiper motor utilising a tumbler drive system for providing forwards / off / reverse feeds and a variable voltage power supply for drive speed.
Mill-Table-drive.jpg
This is a picture of the one currently fitted and in use !Best Regards:
Baron J.
Similar Threads
-
Power Feed For My SX3 Mill
By wm460 in forum METALWORK GENERALReplies: 0Last Post: 29th May 2016, 05:23 PM -
Mill Power Feed Clutch
By Oldneweng in forum METALWORK GENERALReplies: 41Last Post: 22nd Jan 2016, 01:05 AM -
Power Feed for Mill
By Oldneweng in forum METALWORK GENERALReplies: 0Last Post: 17th Oct 2015, 08:28 PM -
Power feed for my mill...
By John Hill in forum METALWORK GENERALReplies: 3Last Post: 11th Jan 2012, 08:11 PM -
mill power feed
By Garry 3 in forum METALWORK GENERALReplies: 4Last Post: 13th Dec 2011, 09:54 PM