Needs Pictures Needs Pictures:  0
Picture(s) thanks Picture(s) thanks:  0
Results 1 to 2 of 2
  1. #1
    Join Date
    Feb 2009
    Location
    jilliby nsw
    Age
    71
    Posts
    111

    Default Hercus Mill X, Y Z feed screws

    Got a question about the Hercus Mill . I believe my small mill was pre metric manufactured so was fitted with dials, graduated in .001". When the country changed over to the metric system the dials were replaced with metric ones. What I dont know is if the feed screws for X,Y & Z axis were changed also.
    This query has been brought about by the fact that my mill like other Hercus mill is vertically challenged on the Z axis. After putting up with minimal work space for years, I have decided to add a 150mm block to the column which will mean an extended Z screw is required.
    Now I have measured the Z Screw and it appears to be square thread , pending inspection with a magnifying glass, it is 0.751" OD and 4mm pitch. An odd combination I know but thats the best fit dimensions I can up with.
    Can any Hercus guru shed any light on the fact that the lifting screw is an original or an upgrade replacement due to metricification. Also have a lot of backlash in the Y feed screw nut that needs to e looked at. The Z screw is not really a problem, being a fitter I'll just make an extension to suit the existing nut, whatever the thread may be, but my curiosity is aroused as the Z screw is not even close to any standard thread I can find, perhaps A Hercus special. Love to hear your thoughts guys

  2. #2
    BobL is online now Member: Blue and white apron brigade
    Join Date
    Feb 2006
    Location
    Perth
    Posts
    7,182

    Default

    I have a metric Hercus
    The vertical screw is 2 mm per turn as is the in-out, the side to side is 5mm.
    I takes two full turn of the Z handle to rotate the Z screw once so it must be a 4mm pitch and a 2:1 reducing bevel gear.

Similar Threads

  1. Hercus Mill - Oiling Longitudinal Feed Handle and Huge Movement
    By NoobHercusOwner in forum THE HERCUS AREA
    Replies: 11
    Last Post: 26th Apr 2019, 09:30 PM
  2. Power Feed For My SX3 Mill
    By wm460 in forum METALWORK GENERAL
    Replies: 0
    Last Post: 29th May 2016, 05:23 PM
  3. Power Feed for Mill
    By Oldneweng in forum METALWORK GENERAL
    Replies: 0
    Last Post: 17th Oct 2015, 08:28 PM
  4. Power feed for my mill...
    By John Hill in forum METALWORK GENERAL
    Replies: 3
    Last Post: 11th Jan 2012, 08:11 PM
  5. Vertical lift screws binding in old horizontal mill
    By 19brendan81 in forum METALWORK GENERAL
    Replies: 19
    Last Post: 26th Aug 2010, 12:15 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •