murphaph
13th Sep 2005, 06:13 AM
Hi all,
Here's my problem. I am replacing a broken motorcyle mirror which threads into the clutch handle assembly. It's an M10 FINE thread. I have been given a nice mirror which is M10 COARSE threaded. I'd like to either buy a male-female standoff with a 10mm fine male thread and 10mm coarse female thread. If this type of thing isn't available, could you advise what size drill bit I'll need to drill the handle assembly before tapping it and inserting an M10 coarse helicoil?
Thanks a lot guys.
Phil, Dublin.
Here's my problem. I am replacing a broken motorcyle mirror which threads into the clutch handle assembly. It's an M10 FINE thread. I have been given a nice mirror which is M10 COARSE threaded. I'd like to either buy a male-female standoff with a 10mm fine male thread and 10mm coarse female thread. If this type of thing isn't available, could you advise what size drill bit I'll need to drill the handle assembly before tapping it and inserting an M10 coarse helicoil?
Thanks a lot guys.
Phil, Dublin.