View Full Version : Easy movement of heavy weights.
azzrock
13th May 2021, 09:38 PM
I've been using this trick/ method . A lot lately
At my new job .we have to very accurately position cars while setting up for a crash. So we position the wheels on top of 2 steel plates with grease in between them. I can easily push a 2 t car side ways buy my self while some one checks the measurements.
The have plates are approx 200mm by 200mm 3mm thick.
KBs PensNmore
17th May 2021, 01:22 AM
Thanks for the tip. Bit hard to get my Horizontal mill up on the plates though.:D
Kryn
Mk1_Oz
17th May 2021, 09:20 AM
I have used the same method when trying to rough align a cars front wheels. Maybe your boss needs to buy you 4 go-jacks (http://www.racerindustries.com.au/afawcs0161690/CATID=345/ID=10188/SID=22324332/Aeroflow-Go-Jack-12)?
azzrock
21st May 2021, 06:08 PM
We have several sets of Go jacks. There very handy. Most of the time there used after the crash. Before hand . The car or barrier have to be possioned very accurately. Today I was pushing a over 1 ton ridgid Frame with one hand. It just had a pair of greased plates under each tire.
azzrock
21st May 2021, 06:10 PM
Thanks for the tip. Bit hard to get my Horizontal mill up on the plates though.:D
Kryn
There only 3mm plates
.RC.
21st May 2021, 08:46 PM
I seem to have no trouble crashing my lathe or mill where they currently are. :D
azzrock
21st May 2021, 09:30 PM
They must be in a good spot . RC.
I haven't been crashing many machine tools lately
Just $400000 hand built prototype cars.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.