Podbuilder
13th Dec 2020, 04:05 PM
Hi All. Thought I'd post some videos of my DIY CNC Mill / Plasma Cutter. I'm just adding rotary pipe cutting or at least trying too. :U
https://www.youtube.com/watch?v=w6-hr0mj9bA
And my first cut of a sign.
https://www.youtube.com/watch?v=u45p4vdiFzI
Im using 2 x Gecko G540's on two parallel ports. DIY controller box. When I'm not metal working the water tray lifts off the back of the table and my spindle fits in where the plasma torch sits. My table surface sits on raills and 4 allthread rods so I can lower the raise the cutting surface. So I've a deep Z axis. :)
Cheers
Brad.
https://www.youtube.com/watch?v=w6-hr0mj9bA
And my first cut of a sign.
https://www.youtube.com/watch?v=u45p4vdiFzI
Im using 2 x Gecko G540's on two parallel ports. DIY controller box. When I'm not metal working the water tray lifts off the back of the table and my spindle fits in where the plasma torch sits. My table surface sits on raills and 4 allthread rods so I can lower the raise the cutting surface. So I've a deep Z axis. :)
Cheers
Brad.