View Full Version : Holding rough stock
morrisman
12th Dec 2013, 07:48 PM
To square up roughly shaped stock in your milling vice , use a ball with a flat machined on its side to hold the stock in the vice while you machine it :2tsup:
BaronJ
13th Dec 2013, 09:01 AM
To square up roughly shaped stock in your milling vice , use a ball with a flat machined on its side to hold the stock in the vice while you machine it :2tsup:
One trick I use is three flute cardboard box cut into strips or styrene foam.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.