View Full Version : Opinions on Sharpening Router Bits?
NGrimberg
15th Jul 2020, 10:59 PM
Is it really a viable option, especially for bits with a specific diameter such as 3/4 or 1/2 inch? How can they be sharpened without affecting their diameter?
elanjacobs
15th Jul 2020, 11:32 PM
Yes it is viable (and very common), yes it affects the diameter, you just change your tool offset to allow for it.
BaronJ
16th Jul 2020, 05:46 AM
Hi Guys,
You will need a diamond wheel for the carbide !
BobL
16th Jul 2020, 09:25 AM
Hi Guys,
You will need a diamond wheel for the carbide !
If the cutter has a "flat" , and a lot of them do then a diamond file can be uses provided the cutter is not too far gone.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.