PDA

View Full Version : First timer



mechdraw
29th Nov 2019, 07:32 AM
Hello All
Just registered as a new member of this forum.
Retired tradie and just purchased a CQ6230a, but have a DM3000 NC lathe.
Hope to help and get help from other members.

Regards

Grahame Collins
29th Nov 2019, 06:57 PM
Hi mechdraw

Welcome to our Forum

It is good to have a few lathes.

There is a sticky above the general Metal Working page that can be read to give you an idea on questions and information needed to get quicker answers..

Sticky: New? Asking a Question - Read This

https://metalworkforums.com/f65/t198793-question-read

Feel free to explore our sub forums for all of what we have to offer. Go to the FORUM box in the LH corner,the one with the little white down arrow and click.
Click again on Forum Home and it will take to the page where all our sub forums and other helpful links are.

Again welcome to a great forum

Grahame

mechdraw
29th Nov 2019, 07:56 PM
Hi mechdraw

Welcome to our Forum

It is good to have a few lathes.

There is a sticky above the general Metal Working page that can be read to give you an idea on questions and information needed to get quicker answers..

Sticky: New? Asking a Question - Read This

https://metalworkforums.com/f65/t198793-question-read

Feel free to explore our sub forums for all of what we have to offer. Go to the FORUM box in the LH corner,the one with the little white down arrow and click.
Click again on Forum Home and it will take to the page where all our sub forums and other helpful links are.

Grahame

Again welcome to a great forum


Thanks Grahame for the welcome.

old1955
30th Nov 2019, 08:56 PM
Welcome to the forum.