View Full Version : First timer
mechdraw
29th Nov 2019, 07:32 AM
Hello All
Just registered as a new member of this forum.
Retired tradie and just purchased a CQ6230a, but have a DM3000 NC lathe.
Hope to help and get help from other members.
Regards
Grahame Collins
29th Nov 2019, 06:57 PM
Hi mechdraw
Welcome to our Forum
It is good to have a few lathes.
There is a sticky above the general Metal Working page that can be read to give you an idea on questions and information needed to get quicker answers..
Sticky: New? Asking a Question - Read This
https://metalworkforums.com/f65/t198793-question-read
Feel free to explore our sub forums for all of what we have to offer. Go to the FORUM box in the LH corner,the one with the little white down arrow and click.
Click again on Forum Home and it will take to the page where all our sub forums and other helpful links are.
Again welcome to a great forum
Grahame
mechdraw
29th Nov 2019, 07:56 PM
Hi mechdraw
Welcome to our Forum
It is good to have a few lathes.
There is a sticky above the general Metal Working page that can be read to give you an idea on questions and information needed to get quicker answers..
Sticky: New? Asking a Question - Read This
https://metalworkforums.com/f65/t198793-question-read
Feel free to explore our sub forums for all of what we have to offer. Go to the FORUM box in the LH corner,the one with the little white down arrow and click.
Click again on Forum Home and it will take to the page where all our sub forums and other helpful links are.
Grahame
Again welcome to a great forum
Thanks Grahame for the welcome.
old1955
30th Nov 2019, 08:56 PM
Welcome to the forum.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.