PDA

View Full Version : Sheraton conquest inquiry



Nick75
3rd Nov 2019, 08:53 AM
Good morning all

I am looking for the wiring diagram for the conquest.
The motor on this as you all would be aware has two sets of windings.
The majority of the starter panel is missing including contactors .
I have found the uk site but before buying a book just for the wiring diagram thought I would see if someone could help out.

Regards

Nick

waxen
3rd Nov 2019, 04:00 PM
whilst I don't have the wiring diagram, I think I have some pictures of the original layout of mine. I replaced the motor with a single speed motor and VFD.
I'll dig them out after I finish watching the Sepang Motogp.

Nick75
3rd Nov 2019, 04:05 PM
Thank you

waxen
3rd Nov 2019, 09:28 PM
Your thanks where a little premature...
I've searched all the sd cards and folders of information I have without success, i'm sorry to say. I'll keep looking and if they turn up you'll hear about it.

Nick75
3rd Nov 2019, 09:37 PM
No problems at all I do appreciate the effort.

Speaking to friend whom i purchased the lathe from he said he has a frequency drive I can use if need be.

As long as the lathe can reach its speed of 2500 rpm ill be happy .
Im not sure if its rated to beyond that in the bearings and lubrication setup as I havnt turned up anything in my research of anyone else doing this to theirs.

waxen
3rd Nov 2019, 09:43 PM
The motor I have put on is rated the same rpm, I use a vector drive VFD and it supplies ample grunt at low speeds

waxen
3rd Nov 2019, 09:45 PM
As an addendum.....the only time I've let the lathe sing at those speeds is to polish