PDW
27th Dec 2018, 10:14 AM
Need 2 pieces of bronze plate 175 x 175 x 3mm thick - nominal.
I am missing 2 port hole trim rings that have a 165mm OD finished diameter and seeing as they are apparently impossible to buy I'm prepared to machine them.
If anyone is set up to cast them that's acceptable too. I've a pottery kiln but don't want to bother as I haven't done it to date.
Also after a slug of bronze 100mm OD x 20mm thick, also nominal.
And yeah I mean bronze, not brass - these will be exposed to salt water, brass ends up a weak spongy copper matrix as the zinc disappears.
PDW
I am missing 2 port hole trim rings that have a 165mm OD finished diameter and seeing as they are apparently impossible to buy I'm prepared to machine them.
If anyone is set up to cast them that's acceptable too. I've a pottery kiln but don't want to bother as I haven't done it to date.
Also after a slug of bronze 100mm OD x 20mm thick, also nominal.
And yeah I mean bronze, not brass - these will be exposed to salt water, brass ends up a weak spongy copper matrix as the zinc disappears.
PDW