View Full Version : Lathe compound angle indicator
robyn2839
16th May 2018, 05:46 PM
my lathe,s Lathe compound angle indicator is worn out and am trying to find a new one ,any idea where to start looking ?
photo 1 is when i GOT the lathe photo 2 is when I washed it with kero, now shiny
Michael G
16th May 2018, 08:56 PM
I'd start by talking to Hare & Forbes as they may have a spare part for that or a similar lathe.
Failing that, if you measure the diameter and do the calculations, you may be able to make up/ engrave a strip of metal that will indicate for you
Michael
robyn2839
16th May 2018, 10:53 PM
no luck with hafco
Grahame Collins
16th May 2018, 11:10 PM
Once you do the calcs, a stainless steel strip could be laser engraved.
Grahame
smxas
17th May 2018, 02:56 AM
Another alternative is to use a sine bar and gauge blocks to set it up and sweep with an indicator.
You can then scribe a few of the common angles. You don't often use the ones in between but you could do a few as required.
It would also be more accurate. I've done a few less common tapers like that and they blued up nicely.
Spiro
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.