MasterSpoon
19th Apr 2017, 12:08 AM
As the title says I'm looking for a ball crank handle for my Taiwanese Bridgeport mill clone. It came with one broken already when I bought it.
I tried to take a picture of my good one but my phone camera failed horribly... This is the type of handle I'm chasing
Mine has a 3mm keyway, ideally close to Toowoomba or if not then need to be willing to post.
Should add that the bore is 5/8inch (15.875mm)
Thickness is 1.060 inch (26.95mm) at the mounting section
So does anyone have one laying around or can point me to where I can buy them at a reasonable price ?
Thanks
Wayne
http://i.ebayimg.com/images/a/T2eC16VHJGwFFY-SmV)bBST,Zchinw~~/s-l1600.jpg
I tried to take a picture of my good one but my phone camera failed horribly... This is the type of handle I'm chasing
Mine has a 3mm keyway, ideally close to Toowoomba or if not then need to be willing to post.
Should add that the bore is 5/8inch (15.875mm)
Thickness is 1.060 inch (26.95mm) at the mounting section
So does anyone have one laying around or can point me to where I can buy them at a reasonable price ?
Thanks
Wayne
http://i.ebayimg.com/images/a/T2eC16VHJGwFFY-SmV)bBST,Zchinw~~/s-l1600.jpg