BobL
10th Oct 2016, 10:10 PM
I decided to convert a 1HP Y motor to ∆ this arvo.
However the common point is at the other end of the motor and there are no pathways available through the inside of the motor.
The only thing I can think of doing is drilling a hole in the end cap and using conduit to take the ends of the coils at the common point back up the outside of the motor to where the other ends are?.
Anyone have any other ideas?
However the common point is at the other end of the motor and there are no pathways available through the inside of the motor.
The only thing I can think of doing is drilling a hole in the end cap and using conduit to take the ends of the coils at the common point back up the outside of the motor to where the other ends are?.
Anyone have any other ideas?