Michael G
21st May 2014, 08:18 PM
Anyone here (preferably in the Adelaide area) that can do good quality Aluminium castings?
As part of my Grinder restoration http://www.woodworkforums.com/showthread.php?t=184859 if I decide to replicate the overhead shaft arrangement I'll probably end up needing 4 off 3-step pulleys - the largest one would be just under 12" diameter.
Michael
As part of my Grinder restoration http://www.woodworkforums.com/showthread.php?t=184859 if I decide to replicate the overhead shaft arrangement I'll probably end up needing 4 off 3-step pulleys - the largest one would be just under 12" diameter.
Michael