PDA

View Full Version : D1-4 Chuck mounting plates



Greg Q
20th Aug 2010, 03:21 PM
Greetings all...I am looking for two chuck backing plates as above, one 6 1/2" and one 8". Will take interstate offers too.

Thanks

Greg

Billy Bignutz
23rd Aug 2010, 08:41 PM
Hi
I assume you have had no luck with Australian distributors. FYI I have bought parts (threading gears) from a company in Taiwan that makes lathes similar/same to most of the Chinese and Taiwanese ones etc from H&F and other local suppliers. The company is Gosan and they were very helpful and much cheaper than locally even after exchange rate, fees, shipping costs etc. Perhaps you could ask them - I would be curious how you go as I have the same backing plate config and you never know when you may want a backing plate.

The name of the contact I used about 6 months ago was Kao

GOSAN MACHINERY CO., LTD.

NO. 131, RUEIHE. ST., DA LI CITY,
TAICHUNG COUNTY TAIWAN R.O.C.
TEL: 886-4-24950259 FAX: 886-4-24934507

E-mail: [email protected] (wlmailhtml:{E6F43ED1-AC27-4442-8BA0-7F9F55CABC19}mid://00000203/!x-usc:mailto:[email protected])

http://www.shyesheng.com (wlmailhtml:{E6F43ED1-AC27-4442-8BA0-7F9F55CABC19}mid://00000203/!x-usc:http://www.shyesheng.com/)

Greg Q
23rd Aug 2010, 09:01 PM
Thanks Billy B.

I'll follow up on your lead.

Greg