Results 1 to 4 of 4

Thread: 59 HSS BA taps

  1. #1
    Join Date
    Feb 2016
    Location
    NSW
    Posts
    104

    Default 59 HSS BA taps

    I have a collection of BA taps I don't need. All are HSS. All quality brands - Sutton, P&N, Ezicut, TEC etc. There is at least one sharp useable tap in each size, and several (if not all) in the larger sizes. Most are quite old (it is BA), and have had some surface rust or pitting at some stage, but all are now cleaned and oiled ready for use.


    0BA 6
    1BA 7
    2BA 6
    3BA 4
    4BA 9
    5BA 3
    6BA 8
    7BA 5
    8BA 4
    9BA 4
    10BA 3

    Looking for $50 posted for the lot.
    Attached Images Attached Images

  2. #2
    Join Date
    Oct 2008
    Location
    Cairns, Q
    Posts
    468

    Default

    PM sent.

    Frank

  3. #3
    Join Date
    Jul 2007
    Location
    sandstone point queensland
    Age
    62
    Posts
    18

    Default

    how did you clean them? I have about 200 I i want to clean,up to about 40mm wide, and about 100 dies ,most are P&N ,then i want to then list them

  4. #4
    Join Date
    Feb 2016
    Location
    NSW
    Posts
    104

    Default

    Taps now sold, thank you all.

    Robyn,

    The hard way, unfortunately. A Dremel and a few of those little wire wheels. HSS is pretty hard so when it does corrode you either get not very deep surface rust, or pinprick pitting, so the rust either comes right off immediately or it you can't touch it. Just takes patience and getting on a roll, sadly. Doing 60 was tedious enough, I don't envy you

    You could use a phosphoric acid bath, but I'm not sure what effect that would have on the overall sharpness of the taps/dies, and in my opinion phosphoric acid usually requires manual cleanup with a brush anyway to remove the... film it leaves.

Similar Threads

  1. Metric Taps M3 - M12 as a set
    By caskwarrior in forum METALWORK - Machinery, Equipment, MARKET
    Replies: 3
    Last Post: 9th Nov 2016, 02:17 PM
  2. Which Taps would you buy?
    By ventureoverland in forum METALWORK GENERAL
    Replies: 29
    Last Post: 30th Jun 2014, 08:32 PM
  3. Does anyone own some ACME taps?
    By Michael G in forum METALWORK GENERAL
    Replies: 14
    Last Post: 2nd Jul 2013, 11:12 PM
  4. taps and dies
    By doug3030 in forum METALWORK GENERAL
    Replies: 23
    Last Post: 10th Mar 2012, 01:44 PM
  5. BA taps
    By morrisman in forum METALWORK GENERAL
    Replies: 9
    Last Post: 23rd Sep 2011, 05:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •