Search:
Type: Posts; User: raygun
Search: Search took 0.00 seconds.
-
29th Feb 2020, 07:04 PM
Thread: Lathe tool height setting gauge !
by raygun- Replies
- 18
- Views
- 5,722
Hi, I also use the 150mm ruler between the tool...
Hi,
I also use the 150mm ruler between the tool tip and a round bar in the lathe chuck for initial setting of lathe tool height then run a couple of cuts on the end of the bar until there is no... -
23rd Oct 2018, 11:01 PM
Thread: Help with tailstock
by raygun- Replies
- 7
- Views
- 2,213
Hi, My Sieg C6 lathe had the same crappy key...
Hi,
My Sieg C6 lathe had the same crappy key on a short post, Real pain the ass.
Recently I Grabbed a suitable bolt from Bunnings and milled the bolt head to match the shape of the key, then... -
Hi, I made two separate purchases off...
Hi,
I made two separate purchases off Banggood.com yesterday, No mention of a GST charge or any extra fee charged,
Regards
Raygun -
21st Jan 2018, 04:52 PM
Thread: Parting Off Blade/Tool Advice
by raygun- Replies
- 57
- Views
- 14,146
I also have the Eccentric Engineering FoR...
I also have the Eccentric Engineering FoR Inverted parting tool, Works VERY WELL, Makes Parting off easy,
Check it out: ... -
18th Jun 2017, 11:49 PM
Thread: Sieg SX4 Mill Measurements
by raygun- Replies
- 10
- Views
- 4,105
Hi Ron, Check with Ausee Machines & Tools...
Hi Ron,
Check with Ausee Machines & Tools they are in Victoria, The guy there was very helpful, they are the Sieg agents in OZ, I got a SX3L off them last year and it cost $145 to ship the SX3L... -
14th May 2017, 04:34 PM
Thread: Bronze source
by raygun- Replies
- 2
- Views
- 2,518
Hi, Contact George Weston 62 Mica Street,...
Hi,
Contact George Weston
62 Mica Street,
Carole Park, QLD 4300 (Brisbane)
Should have what you need
Brass Rounds | George Weston -
14th Sep 2016, 04:08 PM
Thread: Qld : Milling machine / drill press
by raygun- Replies
- 2
- Views
- 4,872
Hi Wayne. I would suggest you take a look at...
Hi Wayne.
I would suggest you take a look at the Sieg Mills, I have just purchased a SIEG SX3L HiTorque Mill it cost $2530 + $145 to ship it from Melbourne to Brisbane with TNT (Collected from TNT... -
23rd Jun 2016, 03:30 PM
Thread: Best way to remove these sheared bolts
by raygun- Replies
- 17
- Views
- 4,672
Hi, If you are drilling out a broken bolt to...
Hi,
If you are drilling out a broken bolt to use a stud extractor I use a Left hand drill bit.
I have a set of left hand drills (from a OZ ebay seller) which when used in a drill running in... -
8th May 2016, 08:26 PM
- Replies
- 1
- Views
- 1,431
Looking for a good Steel supplier on Brisbane, Qld, (North side)
Hi
I am looking for some where to get Lathe & Milling steel supplies on the north side of Brisbane,Qld. The local steel suppliers I have checked out mainly stock building & fencing tubular stock....