Search:

Type: Posts; User: onetrack

Search: Search took 0.00 seconds.

  1. Sticky: Thanks Mick, the job was a couple of years ago,...

    Thanks Mick, the job was a couple of years ago, and I "got 'er done" without any major drama. The turntable (5th wheel to our U.S. friends) wasn't mounted on a truck it, was mounted on the end of a...
  2. Replies
    21
    Views
    7,159

    I use, in order; 1. Steel 2 door cabinets with...

    I use, in order;

    1. Steel 2 door cabinets with plenty of close-spaced shelving. The older they are, the thicker the metal in them.
    2. 3-level tool trollies. Got 3, they're on wheels, that's the...
  3. Sticky: While I must agree that operator misuse is the...

    While I must agree that operator misuse is the largest reason behind angle grinder accidents, there are scenarios where mechanical failure can also create the scene for an accident.
    I have an old 9"...
  4. lamestlama - Your GMF grinder would be a 1950's...

    lamestlama - Your GMF grinder would be a 1950's model, for sure. It's a very nice example of some of the great post-WW2, Australian-designed-and built, workshop equipment, designed to last more than...
  5. Replies
    12
    Views
    9,109

    No, No and No. Commodores are metric, and HQ-WB...

    No, No and No. Commodores are metric, and HQ-WB hubs are Imperial (inch) measure - and never should the two be mixed.

    Not only is the wheel stud PCD different, the Commodore studs (and therefore...
  6. Replies
    16
    Views
    10,052

    I've often thought the same thing - and so many...

    I've often thought the same thing - and so many times, I've been to auctions where equipment and accessories were separated and sold to different buyers, with very few people aware of the importance...
  7. Replies
    4
    Views
    1,352

    There was a similar episode where certified...

    There was a similar episode where certified lifting equipment (seem to recall it was D-shackles) from our Northern neighbour, was imported into the U.S. and sold - then these "certified" items...
  8. Replies
    6
    Views
    10,465

    Yep, not a problem, they will weld 6mm plate...

    Yep, not a problem, they will weld 6mm plate quite satisfactorily. These new inverter welders are great.
    I've got an old CIG Transmig 130 twin (non-inverter) that I picked up for $150 about 3 or 4...
Results 1 to 8 of 8