Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Tool ID please.
-
9th Nov 2008, 08:59 AM #1
Tool ID please.
I bought some hole saws at an auction and this set of gadgets was included in the lot. After serious efforts to work out what they're used for we gave up. Does anyone have any idea?
-
9th Nov 2008, 10:24 AM #2"Outside of a dog a book is man's best friend ,inside a dog it's too dark to read"
Groucho Marx
-
9th Nov 2008, 10:31 AM #3
They're used for putting the raised section on the tube as pictured with the short bits of tubes.
You put them in the end of the appropriate sized tube and then screw them up so that the ball bearings roll the impression in the tubeCheers
DJ
ADMIN
-
9th Nov 2008, 10:42 AM #4
Brilliant. Thanks. I had no idea.