Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 2 of 2
Thread: Metal master AL-356 Owners
-
30th Dec 2018, 05:23 AM #1New Member
- Join Date
- Dec 2018
- Location
- New Zealand
- Age
- 76
- Posts
- 2
Metal master AL-356 Owners
Hi all I recently purchased a metal master AL-356v .Seems to run ok but the usual asian problems lots of swarf were it shouldnt be but you get what you pay for. My gripe is that the pinion gear for the table drive lost two teeth when I had a senior moment and allowed the auto feed to bottom out. This should have been prevented by the spring loaded ball clutch on the table drive releasing .But this dident happen as the assemblers screwed the bearings in that tight they didnt release.As it is the xmas break braised up the gear and re cut the teeth I will be haveing a talk with Machinery House
-
31st Dec 2018, 09:27 PM #2
Hi Bob404
Welcome to our Forum.
I moved your post as it was in the wrong place and not likely to be seen for a while.
The section you posted in was for technical aspects of our Forums -programme problems and such.
Grahame
Similar Threads
-
Aussie AL-960 owners or previous owners input please?
By befuddled in forum METALWORK GENERALReplies: 4Last Post: 6th Jun 2015, 10:14 PM -
for the shaper owners
By fxst in forum METALWORK GENERALReplies: 13Last Post: 19th Apr 2012, 11:27 PM -
24 Hercus Owners and still looking
By bitza500 in forum THE HERCUS AREAReplies: 19Last Post: 24th Dec 2008, 10:39 AM -
perth hafco metal master bandsaw
By thesupervisor in forum METALWORK GENERALReplies: 12Last Post: 11th Sep 2007, 09:46 PM