Likes: 0
Needs Pictures: 0
Results 1 to 7 of 7
Thread: Tangential tool holder.
-
8th Jul 2018, 11:56 AM #1Banned
- Join Date
- Jan 2018
- Location
- Aldinga Beach.
- Age
- 73
- Posts
- 148
Tangential tool holder.
Whenever I use the tangential I find after a while the cutting tool slides down in the holder. Anybody have this happen?
-
8th Jul 2018, 12:00 PM #2Senior Member
- Join Date
- May 2011
- Location
- Castlemaine
- Posts
- 244
Never happened with my "Diamond" tool holder from Eccentric Engineering.
cheers
Piers
-
8th Jul 2018, 12:16 PM #3
I have found mine has slipped while doing some projects some times. In my case I put it down to the cutting bit losing its cutting edge because the material being cut was quite hard. I have had to "lay into" the hex bolt/clamp to stop it slipping. I think in frustration I ended up using a carbide cutter in another holder to get the job done.
Just do it!
Kind regards Rod
-
8th Jul 2018, 01:26 PM #4Most Valued Member
- Join Date
- Jul 2006
- Location
- Athelstone, SA 5076
- Posts
- 4,258
nope!
-
8th Jul 2018, 06:59 PM #5
Hi Rod,
Use some double sided adhesive tape underneath the clamp !Best Regards:
Baron J.
-
8th Jul 2018, 07:34 PM #6Golden Member
- Join Date
- Nov 2010
- Location
- Gippsland Victoria
- Posts
- 733
Stop tangential from slipping
I had that problem.
Here is how I fixed it.
Tangential.JPG
My two capscrews and washers to hold the cutter are quite flimsy compared to many of the holding mechanisms I've seen on the web.
Bill
-
9th Jul 2018, 04:12 AM #7Most Valued Member
- Join Date
- Nov 2017
- Location
- Geelong, Australia
- Age
- 57
- Posts
- 2,673
Similar Threads
-
Tool Holder for HBM
By Mike4 in forum METALWORK GENERALReplies: 6Last Post: 20th Jan 2016, 10:17 AM -
Tool sharpening attachment for DIY tangential
By th62 in forum METALWORK GENERALReplies: 8Last Post: 21st Aug 2013, 09:12 PM -
Tool holder I.D. ?????
By morrisman in forum METALWORK GENERALReplies: 16Last Post: 16th May 2013, 08:19 AM -
tool holder id
By azzrock in forum METALWORK GENERALReplies: 10Last Post: 8th Dec 2011, 03:25 PM -
hss tool holder
By tanii51 in forum METALWORK GENERALReplies: 3Last Post: 11th Nov 2009, 08:31 AM