Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
Thread: Force-brand tools???
-
14th Jun 2011, 02:35 PM #1Intermediate Member
- Join Date
- May 2010
- Location
- Sydney, Australia
- Posts
- 31
Force-brand tools???
Does anyone have any experience with Force Tools?
Force Tools Australia
It's an Australian company and appears to be reasonably priced and appear to be involved mainly with automotive tools. Not cheap but not expensive. I'm just looking for some new hand tools and haven't heard much about them.
They appear to be sold through Trade Tools.
Thanks,
Ben
-
14th Jun 2011, 02:41 PM #2Dave J Guest
-
14th Jun 2011, 03:27 PM #3Intermediate Member
- Join Date
- May 2010
- Location
- Sydney, Australia
- Posts
- 31
Thanks for that.
I realise they probably aren't as good as Sid or Snap On but the price of the Force is very reasonable compared to them.
I'm surprised they can be bought through Repco. I thought they only stocked the Repco & Mechpro brand.
FWIW I've found that they are manufacturered in Taiwan.
-
14th Jun 2011, 03:54 PM #4Dave J Guest
I really didn't take much notice when he said force brand as I have all the spanners/sockets I could ever use up to about 2inch/50mm, so had to think hard when you posted if that was the brand he mentioned and I am sure it was.
He said his brother worked there and he bought through them because of the discount. He was quite happy with the quality, but said if you where using them everyday for coin, you would be better of the others mentioned above (In his opinion)
I have got Taiwanese spanner that I bought when I was young and they are still going strong. They where the days when everybody was bad mouthing Taiwanese tools, but little did they know then the wave of Chinese tools would hit us and be worse. LOL
These will never be as good as my sidchrome, but most are standing up.
Dave
-
15th Jun 2011, 10:49 PM #5Senior Member
- Join Date
- Jul 2008
- Location
- Sydney
- Posts
- 210
Ben,
I was about to link you to Outerlimits4x4 but noticed this post is almost identcal to one there so I assume you possed the question over there as well.