Results 1 to 2 of 2

Thread: valve seats

  1. #1
    Join Date
    Jul 2008
    Location
    near Warragul, Victoria
    Posts
    3,115

    Default valve seats

    I thought I had repaired the poorly made Indian seat cutters but on closer inspection, they still had a nasty runout problem. I tried another method, I used a 4 jaw chuck and turned up a 30 degree seat for the 30 degree cutter , the cutter sits in the seat in the 4 jaw chuck and I then bore the cutter centre out , so in theory the 30 degree face will be concentric with the bore . Another problem was the arbor and the pilot were not concentric either ! gee these damn cheap rubbish tools . I decided to bore the end of the arbor and press the pilot in, then turn the whole thing between centres, this method worked ! Hopefully I now have a concentric setup , the cutter will be a press fit onto the arbor , this should last long enough for my one off job
    Attached Images Attached Images

  2. #2
    Join Date
    Jan 2011
    Location
    Far West Wimmera
    Age
    57
    Posts
    3,916

    Default

    gee these damn cheap rubbish tools .
    Some you win, some you lose.

    Dean

Similar Threads

  1. valve guides
    By morrisman in forum METALWORK GENERAL
    Replies: 20
    Last Post: 13th May 2017, 06:13 PM
  2. Compressor Non-return Valve
    By electrosteam in forum METALWORK GENERAL
    Replies: 11
    Last Post: 6th Jun 2014, 11:45 AM
  3. pot belly butterfly valve
    By kraits in forum METALWORK GENERAL
    Replies: 26
    Last Post: 3rd Jul 2011, 04:28 PM
  4. Does anyone know the die size for tyre inflation valve?
    By Fossil in forum METALWORK GENERAL
    Replies: 3
    Last Post: 22nd Nov 2007, 11:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •