Thanks Thanks:  0
Likes Likes:  0
Needs Pictures Needs Pictures:  0
Picture(s) thanks Picture(s) thanks:  0
Results 1 to 4 of 4

Thread: Spiral clamps

  1. #1
    Join Date
    Oct 2011
    Location
    Norwood-ish, Adelaide
    Age
    59
    Posts
    6,540

    Default Spiral clamps

    I, like a lot of others, have admired Bob's spiral clamps so when I spotted these as a job lot on German ebay for a (relatively) good price I thought great- I'd love to have some of them. I expected to swap over a T-nut as my mill table has 18mm slots and be flying, but no. The T-nuts have a long stem on them and although I could make new ones it would be a job I don't have time for at the moment and probably take a while to do too. Then I thought that as the nuts were for a 12mm slot, I could use them on my rotary table. I had that out today and discovered a second no - as well as the slot on the table being smaller, the clamps are big enough that if they are on the table there is not much room left for anything else. Back to the nuts and clamp kit...
    P1030685 (Large).JPG
    Anyway, I would now like to sell these on so I don't have to look at them every time I walk in the shed. There is 1x 0-15-45 clamp, 3x 30-75 clamps and 2x 60-135 clamps, suitable for a mill with 12mm or 1/2" T-slots. All but one have 'SP' on the bolt heads (the one that doesn't has the recess for the label but no label). I would like to recoup my outlay, so the asking price is $480 (which was purchase plus postage), but I will include postage for them within Australia at that price.

    Michael

  2. #2
    Join Date
    Jun 2012
    Location
    ex Perth, now Mittagong
    Posts
    105

    Default

    Michael,

    email sent.

    Peter

  3. #3
    Join Date
    Oct 2011
    Location
    Norwood-ish, Adelaide
    Age
    59
    Posts
    6,540

    Default

    Thanks Peter. Response sent.

    Michael

  4. #4
    Join Date
    Oct 2011
    Location
    Norwood-ish, Adelaide
    Age
    59
    Posts
    6,540

    Default

    Sold.

    Michael

Similar Threads

  1. Paulcall clamps
    By Petip in forum METALWORK GENERAL
    Replies: 7
    Last Post: 25th Oct 2015, 06:40 PM
  2. Hand taper pin reamers, spiral flute v straight flute
    By bob ward in forum METALWORK GENERAL
    Replies: 11
    Last Post: 22nd Jul 2014, 09:30 PM
  3. More Helix Clamps
    By Anorak Bob in forum METALWORK GENERAL
    Replies: 3
    Last Post: 11th Aug 2013, 11:31 PM
  4. SPIRAL Vs STREIGHT FLUE TAPS
    By kraits in forum METALWORK GENERAL
    Replies: 5
    Last Post: 6th Jul 2011, 12:38 PM
  5. Low Profile Clamps
    By John H in forum METALWORK GENERAL
    Replies: 9
    Last Post: 7th Jan 2010, 11:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •