Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 10 of 10
-
21st May 2010, 03:10 PM #1
Lathe for Lathe Drill Mill (Near Liverpool NSW)
I have a Takang TK-101b Lathe 12" x 26" (300mm x 600mm), full set of gears 16 of them, 3 & 4 Jaw chucks, Face plate, Steady, Left, Right and Straight tool holders , Parting Tool, 4 way tool post, some assorted bits, dead centre etc. Lathe was my fathers and always well maintained, I have had it for about 6 years and given it very little use, it is 240volt, needs a little TLC, but is still very accurate.
Looking to swap it for a Lathe Mill Drill Combo, preferably with 500mm between centres.
Located at Canley Heights (near Liverpool)
-
4th Jun 2010, 04:10 PM #2
Sale?
Any chance of selling this.
If so how much?
Liam
-
4th Jun 2010, 05:01 PM #3
Missed seeing this would love a photo I'm just round the corner so to speak
-
4th Jun 2010, 05:25 PM #4
Will try and get a photo or 2 over the weekend.
Cheers
-
9th Jun 2010, 11:02 AM #5
Here are a couple of pictures.
-
9th Jun 2010, 11:18 AM #6
Lathe
Looks Like a nice little machine.
-
9th Jun 2010, 12:00 PM #7
-
9th Jun 2010, 12:26 PM #8
Auskart, could I suggest you put a price on this lathe?
I realise that you would like to swap, however there would probably be more interest from members in a straight out sale, as has already been indicated.
-
9th Jun 2010, 12:55 PM #9
Really looking to swap it, but will take $1800 ONO
A Little bit of Info.
- Distance between Centers 600mm (26")
- Swing over Bed 300mm (12")
- Spindle Bore 28mm
- Adjustable Roller Bearings in the Head
- Multiple Oiling Points
- 240 Volt
- Hardened Bedways (absolutely NO wear)
- 4 Way Tool Post
- 130mm 3 Jaw Chuck
- 200mm 4 Jaw Chuck
- 200mm Face Plate
- Left, Right and Straight Tool Holders
- Parting Tool
- 16 Change Gears (for thread cutting)
- 13mm (1/2") Drill Chuck and Key M2 Taper
- Dead Center
- Assorted spare cutting tools and tool steel
- Fixed Steady
- Heavy Duty, Solidly Built Lathe
-
29th Jun 2010, 07:02 PM #10
Lathe is Sold.
Similar Threads
-
my lathe and mill
By knicko in forum METALWORK GENERALReplies: 2Last Post: 9th Feb 2010, 01:22 PM -
using lathe for mill
By Grahame Collins in forum METALWORK GENERALReplies: 25Last Post: 10th Jun 2009, 01:30 AM -
Lathe/drill/mill combo. or AL-320G
By KevinR100 in forum METALWORK GENERALReplies: 4Last Post: 1st Mar 2007, 12:56 AM -
Lathe /Mill
By DavidG in forum METALWORK GENERALReplies: 7Last Post: 11th Nov 2006, 08:21 AM